Bracket is made from 1/8 inch 3003H14 aluminum and comes bare unfinished metal or with OEM paint, high vertical, low vertical and horizontal . Bracket angle is fully adjustable but is designed to be mounted at the angle shown for optimal wind deflection and visability. 1/2 inch mounting hole (mounts to most metric and Harley shock bolts or belt drive/chain covers etc). Fits 4x7 inch license plates.
Fill in the " BLACK HOLE " in the front of your metric cruiser with this radiator cover. I install a chromed aluminum mesh and paint 'em up to match or contrast your bike....if you have a black bike you need a cover with a few coats of gloss black and some clear coat to make it stand out a little and the mesh draws just enough attention, unlike the all chrome covers that tend to look like old hood ornaments (JMO).
(NEW MESH PATTERN PICTURED ON SILVER COVER BELOW)
**These are for the VTX 1300 only, 1800 covers must be sent in for painting only...no mesh installed .... we do 750 covers as well, prices are slightly higher than 1300 covers **
This is for those of us that are vertically challenged, want a lower scoot or just like an open shock design. Just send me your chrome enclosed shocks and I'll modify the cases and the springs for you. the springs on 1300 shocks comes in at 8 3/4 and gets cut to a little over 7 1/2, 1800 springs are a little longer so an extra coil is removed from them. a noticable difference will be felt as soon as you saddle up.
*for those that are severly height challenged you may want to look into getting your seats modified as well.
Wire: 3 foot 24 gauge silver stranded Teflon coated 30 inches shrink tube. Fully water proof. Frame can be used either vertically or horizontally.